Terminal in PCB Manufacturing :
How do you know that PCB Manufacturing sees this line connected here? This line over here is connected to which One it’s connected to this point, and it’s connected to this point. How do they know by the meter? The meter says if there’s continuity now, let’s go over here. The meter is zero, meaning there is a connection between here and here. Why do this? Sometimes there are broken pads and broken terminals from plugging and Unplugging. The modules in automotive, so the first thing is to do people do a Visual is not good enough you have to take the pros. You just showed you go from this point to ensure continuity, which means that there is a connection from here to here; anything broken within these two points will give you. So far, they’re all good; we all measured zero zero zero again; what about these two points you just showed you?
When it comes to PCB Manufacturing, you have to measure continuity ohms. Where does this go to flip over the module? If you look and see this, that’s it; they’ll call this pin one. They’ll call this pin two; where does it go to? You see this silver it the other side of it? As you can see, it goes to this relay. What about this one? Where does this go to this side of the relay? If they turn it over, which two pins do you see correspond to these two pins? Take the die out of the way. These two pins correspond to the relay; this is a relay where’s the other ones, so these are two pins for the relay correct As.
Relay in PCB Manufacturing :
The PCB Manufacturing officials said over here these other two are the other two points terminals of the relay, so you can see two pins over here. The relay to repeat They want to find what’s connected to these two points, all these points you picked points. Because these are easy to see, They said this is a relay; the two points going to these relay one over here with that they can see the other One easily. The other two points of the relay flip it over are these two points. So one point, two points, three-point four points for this relay which is on this side over here, this goes to wherever it’s going to, and this is going to one point of the relay.
As you can see, it’s easier with schematics, but when you have problems, you’re looking for broken parts of the board; remember, when you specify, the Vibration will break these boards. Now in a way that, let’s say, this point is connected to this point, you see this all this point up to here is one point. If there’s a crack over here, it will separate these Points. If you need a good magnifying glass to see where the break is, that’s number one; that’s when you’re doing a visual that’s the most you can do, You said. There are no wiring diagrams for these types of things; it’s not even cost-effective. What you’re looking for is these pins over here.